About Company
Job Info
Job Status: Expired
No of Vacancies: 78
Date Posted: February 4, 2019
Expiry Date: February 06, 2019
Job Type: Full Time
Job Level: Mid level
Years of Experience: 05
Salary Info
Salary Type: Negotiable
Apply on this job
This job already Expired,
Application not allowed this job status.
Share this job



Educational Requirements:
 Knowledge of English language.
 Diploma or Industrial Trade training Certification from recognized institution.
 Training & certification from Compressor / Turbine manufacturer and “Dry gas
seal certification” from reputed seal manufacturer will be preferred.
Work Experience:
 Must have good knowledge of safety requirements in Petrochemicals, Oil & Gas
 Must have minimum 10 years of work experience as Compressor/ Turbine
Technician in a Petrochemical, Oil & Gas Plant.
 Must have Working experience & Knowledge in repair and overhauling of
various multistage HP Centrifugal compressors (Horizontally spilt & Barrel type)
of make GE-Nuovo Pignone, Mitsubishi, Dresser Rand, etc.
 Must have Working experience & Knowledge in repair and overhauling of
various multistage Special purpose Steam Turbines (Condensing/ Back
Pressure/ Extraction) of make GE-Nuovo Pignone, Mitsubishi, SIEMENS, ABB
 Must have worked on at least 3 to 5 Compressor / Steam turbine overhauls as
hands on lead technician.
 Working experience in removal and installation of john crane make dry gas seals
on the compressors will be advantage.
 Working experience in Shutdown and Turnaround will be preferred.
 Knowledge of rigging signal and basics in compressor rigging work will be added
 Must be able to operate overhead cranes for removing & installing rotors /
casings and other components of compressor and turbines.
 Typical Plant experience will be an added advantage.


Job Description:
 Ability to perform the work safely and independently.
 Ability to dismantle and assemble each and every compressor and turbine
component as per checklist.
 Ability to take alignment readings using Laser Alignment kit and interpret the
readings and correct them.
 Ability to carry out shaft run-out check, bearing/ labyrinth clearances and
document them in the check list.
 Ability to read & understand Equipment manuals, Datasheets etc and work per
the procedures
 Ability to take readings using various measuring tools and interpret them against
the technical data from the manual. Ability to handle hydraulic tools for coupling,
thrust collar removal etc.
 Ability to read drawings and instruction, to install /remove rotating equipment or
 Assist in preparing Job Safety Analysis
 Ability to identify and use proper tools during overhauling.
 Ability to identify any safety related problems and technical problems and notify
immediately to immediate supervisor.